Drywall & Painting
Patches you can't see. Paint lines you can.
Patches you can't see. Paint lines you can.
Flooring projects often reveal wall damage — scuffs behind old baseboards, holes from removed fixtures, texture that needs matching. We handle all of it so the finished room looks complete.
Drywall Repair After Flooring and Remodels
When old baseboards come off during a flooring project, they leave a strip of damaged drywall behind — nail holes, torn paper, adhesive residue, and a line where the old paint stopped. When old tile backsplash is removed, it pulls chunks of drywall with it. When plumbing is relocated for a bathroom remodel, it leaves open wall cavities that need patching.
We handle all of this as part of your project. Our crews carry joint compound, mesh tape, paper tape, and a full range of texture tools. Patches are floated, sanded, primed, and painted to match the surrounding wall. The goal is invisible — no one should be able to tell where the repair was done.
For Inland Empire homes where the drywall behind baseboards has been exposed for 20 years, we often recommend a fresh coat of paint on the entire wall rather than trying to blend touch-ups with faded existing paint.
Texture Matching: The Hardest Part of Drywall Repair
Most Temecula, Murrieta, and Menifee homes built from the 1990s through 2010s have orange peel or light knockdown texture. Matching that texture on a patch requires the right mix viscosity, the right air pressure, the right nozzle, and — most importantly — practice.
We test spray on scrap drywall before touching your wall. Once the pattern matches, we apply, let it dry, prime, and paint. For knockdown texture, we spray and then flatten with a wide knockdown knife at the correct timing — too early and it smears, too late and it pulls.
Smooth walls are actually harder to patch invisibly than textured walls. Every imperfection shows under side light. We skim-coat patches with three coats of topping compound, sanding between each coat, to achieve a flat finish that is indistinguishable from the original surface.
Interior Painting Standards
We use premium-grade interior latex paint — Sherwin-Williams or Benjamin Moore — in the finish appropriate for each surface. Eggshell for walls, semi-gloss for trim and baseboards, flat for ceilings.
Every surface gets a coat of primer if bare drywall is exposed, followed by two coats of finish paint. We cut in by hand at ceiling lines, corners, and trim edges. Roller coverage uses a consistent nap length and application pressure to avoid lap marks and stipple variation.
Painter's tape goes on every surface that needs protection — newly installed floors, countertops, windows, and hardware. Drop cloths cover all furniture and flooring in the work area. We touch up after tape is pulled to ensure clean, sharp lines at every edge.